I simply began studying to energy carve and determined to carve this finish desk for a bit extra observe. All that it actually takes to get began is an angle grinder and a $60 shaping wheel. I made a decision to make use of up a few of my actually cool spalted maple on this finish desk undertaking. Which was a little bit of a problem, however ultimately, I used to be very proud of the way it turned out. Let me know you probably have any questions for me!

Go give Sawyer Design some love!

Related movies and blogs:
Bandsaw jig:
Power carving weblog:

Items used on this video:
Extreme Disc, Coarse –
Original Ball Nose Burr, 1/4″ Shaft, Fine –
8″ Half-Round Rasp, Fine –
Extreme Taper Burr, 1/4″ Shaft, Very Coarse –
Original Flame Burr, 1/4″ Shaft, Fine –
Lumber rack:
Bosch miter noticed:
Laguna Bandsaw:
Bosch jigsaw:
Bosch angle grinder:
Makita die grinder:
Oscillating device:
Vacuum clamps:
Woodhaven router sled:
Osmo 3043:
Festool domino:
Clamps:
Drum sander (one measurement smaller):
Router desk:
60-degree router bit:
Water-based end:

0.00 Intro
0:27 Rough Cutting Before Carving
1:23 Bandsaw Circle Jig
2;24 Power Carving With Kutzall and Angle Grinder
4:37 Detail Carving and Smoothing
5:35 Hand Shaping With Rasps and Sander
6:45 Bad Idea
7:15 Fixing Bad Idea
8:19 Finishing With Seal A Cell
10:10 Suspicious ‘Hole’
11:36 Spalted Maple Top
12:46 Finishing Spalted Maple Table Top
13:08 Mounting The Table Top On Pedestal
13:39 Product Photography Shots At Home

source

LEAVE A REPLY

Please enter your comment!
Please enter your name here