We might obtain a fee if you use our affiliate hyperlinks. However, this doesn’t influence our suggestions.

While making Shaker bins, I constructed a jig to precisely rip 1/16″ thick strips with out getting my palms too near the blade. In truth, I can go away the guard on the noticed.

The jig has two components. First, there’s a monitor that mounts on the noticed, subsequent to the fence. Two rare-earth magnets recessed into the underside of the monitor preserve it from sliding. The monitor is positioned 1/16″ away from the blade, or at no matter thickness of strip I need to rip.

The second a part of the jig is a push block. (I name it a shoe.) It slides in a groove on the monitor. The shoe has a 1/8″ thick sacrificial cleat that hooks over the again finish of the board I’m ripping. The cleat has slots in it, so I can transfer it up or right down to accommodate boards of various thicknesses.

To reduce a strip, I put a magnetic featherboard on the left facet of the board I’m ripping to maintain the board tight in opposition to the monitor. Then I feed the board into the noticed by hand, similar to every other rip reduce.

When the top of the board is even with the monitor, I put the shoe on the monitor and push the board the remainder of the best way by the reduce. The entrance edges of the shoe and cleat are rounded to permit the blade guard to trip up and over the jig. –Joe Scharle


Product Recommendations

Here are some provides and instruments we discover important in our on a regular basis work across the store. We might obtain a fee from gross sales referred by our hyperlinks; nonetheless, now we have fastidiously chosen these merchandise for his or her usefulness and high quality.



Source link

LEAVE A REPLY

Please enter your comment!
Please enter your name here