We might obtain a fee if you use our affiliate hyperlinks. However, this doesn’t influence our suggestions.
After years of wishing my outdated workbench had a tail vise, I spotted I may make one among my new Jorgensen Cabinet Master bar clamps do the job. All I needed to do was reverse the sliding decrease jaw (it’s detachable) and mount the bar and glued jaw beneath the benchtop.
I drilled and chiseled out an elongated gap within the leg so the sliding jaw would prolong solely 5/8“ above the benchtop. Then I lag-screwed a notched block and cap on the reverse finish to behave as a bearing floor for the mounted jaw. To end my tail vise, I drilled a row of 11/8“ diameter holes in step with the sliding jaw and long-established a bench canine to suit.
When I would like to make use of the clamp elsewhere, I simply take away the sliding jaw and pull the mounted jaw and bar out from the opposite finish —Robert A. Miller
Product Recommendations
Here are some provides and instruments we discover important in our on a regular basis work across the store. We might obtain a fee from gross sales referred by our hyperlinks; nevertheless, we’ve got rigorously chosen these merchandise for his or her usefulness and high quality.
